When applying Cool Flex, hold the arrow under hot water to loosen, align broadhead with vanes and then dip in cold water to lock and seal. Instant full strength set-up in cold water. Easy to apply and even easier to adjust or remove as it is heat reversible.
Heat reversible means if at a later time you want to remove your points & inserts, you just heat up the end of the shaft over the flame of an alcohol burner and just remove the point or insert. Make sure you rotate your aluminium shaft fairly rapidly to broadcast heat without damaging the exterior of the shaft.
Simply apply Cool Flex Hot Melt to an open flame and heat adhesive until it is about to melt. The melting point for Cool Flex is about 200 degrees F. Apply adhesive to insert. Install insert and rotate one full turn. Wipe excess adhesive from shaft. Cloth gloves are recommended when using Cool Flex with heat.
- Royal blue colour stick
- 12 gram stick
- Heat reversible
- Easy to apply super strong
- Melts at lower temperature
- Easy to apply, adjust, or remove
- Full strength set-up in cold water
- Specifically formulated for carbon arrows, stick will do about 144 inserts
- A Bohning Alcohol Burner is the easiest, most convenient way to heat Bohning Cool Flex. Alcohol Burner can be purchased separately
- Manufactured in the USA
- Application: Hot melt
- Weight: 12g
- Formulated for carbon arrows, but will work on all arrows
- 1 x Bohning Ferr-L-Tite Cool Flex Hot Melt Stick 12g